Trim Tab Light Specifications High-tech polymer housing Mounts to trim tab or L bracket. Low DC power consumption. 12 or volt DC power source Draws less than amp @12 volt DC Low heat emission Can be run out of water (while boat is planning) 3 x Long life high output LED’s No bonding required No corrosion 3.7 metre. (12ft.) tined underwater cable Available in Ultra Blue, Ultra Green and brilliant White 2 year warranty Australian designed and manufactured

 

Trim Tab Fitting Instructions

All Aqualuma lights have been tested before shipping.
It is recommended that you use a qualified boat builder to work out placement and fitting of your new underwater lights.

You will require the following to install your new Aqualuma lights:
-6 mm/1/4’ drill, 5 or 6 cable/zip ties and a Fuse or Circuit Breaker

Step 1
With boat on hardstand or trailer work out where to fi t light unit to Trim tab or angle bracket and mark hole centres as set out below.

Step 2
Drill the 2 holes required to mount the unit to the Trim Tab or Bracket.

Step 3
Using the 2 nylock nuts and bolts supplied attach the unit to the Trim Tab or Bracket and tighten until just tight (do not over tighten) the nut and bolt need only to be tight enough to stop the unit from moving on the mount.

Step 4
Mark out and drill a 6mm/1/4’ hole well above the waterline for the wire and feed wire through. Cable tie wire where needed then apply sealant around hole and clean.

Step 5
Connect the wires to a joiner box if using more than one light then run a positive and negative feed from a fused switch to the joiner box.

*Please note red wire is positive and black is negative.

Download printable PDF for Trim Tab Fitting Instructions

Testimonials